直线切割锯床的使用讲解

1、锯床上的液压油应加足,滑动和转动部位抹上一层机油；
1, the hydraulic oil on the sawing machine should be added, sliding and rotating part of the oil;
2、带锯床装上锯带,调节涨紧装置使锯带涨紧达到合适程度,调节好行程开关触头刚好碰到挡铁,处于开启状态；
2. The sawing machine is mounted on the saw belt, adjusting the tightening device to make the saw belt tighten to the right degree.
3、接上电源必须标准可靠,开启电源开关,开动锯试车,按照标牌上所注明旋向校正接线,同时听其响是否正常；

3, the power supply must be reliable, open the power switch, open the saw test, according to the sign on the direction of the rotation correction connection, at the same time listen to its sound is normal;

4、检查升、降油缸装置,检查锯弓抬起和落下,是否可靠灵活；
4, check up and drop the oil cylinder device, check the saw bow to lift and drop, whether it is reliable and flexible.
5、检查夹紧、放松油缸装置,检查夹紧时是否夹紧可靠,放松是否灵活；
5, check the clamping and relaxation of the oil cylinder device, check the clamping when clamping reliability, relaxation is flexible;
6、在主电机电源开关开启后,水泵相应同时启动,冷却系统正常运转.调试阀门,检查冷却液是否流畅；
6. After the main motor power switch is opened, the pump starts at the same time, the cooling system operates normally. The valve is debugged to check whether the coolant is fluent.
7、做好以上准备工作后,装料夹紧锁定,进行试锯削.
7. After doing the above preparation, the loading is clamped and locked, and the test sawing is carried out.